ECU 000613.31 is set off when a fault is detected in the circuitry of the fuel pressure control valves, which could involve issues ranging from electrical faults to mechanical failures within the valve assembly.

READ MORE

This error code, ECU 000613.04, indicates a grounding issue in the circuit of the fuel pressure control valves, potentially causing disruptions in fuel pressure regulation.

READ MORE

ECU 000613.03 is activated when the circuit of fuel pressure control valves is either open or shorted to a 12-volt source, leading to potentially incorrect fuel pressure management.

READ MORE

This diagnostic trouble code, ECU 000612.04, is triggered when the circuit of injection valves 4 to 6 is shorted to ground. This can impair the electrical function of the injectors, potentially leading to engine misfires or reduced engine performance.

READ MORE

Error code ECU 000612.03 indicates a fault in the circuit of injection valves 4 to 6, with a condition of being open or shorted to a 12-volt source. This condition can lead to uncontrolled fuel injector operation, affecting engine performance.

READ MORE

ECU 000611.04 is set when the wiring of electronic injectors (valves 1 to 3) is detected to be shorted to ground. This can lead to inadequate fuel delivery, resulting in engine performance issues such as rough idling or failure to start.

READ MORE

This code, ECU 000611.03, occurs when the wiring of electronic injectors (specifically for valves 1 to 3) is found to be shorted to a power source, typically 12 volts. This electrical fault can cause uncontrolled injector operation, leading to engine misfires or over-fueling.

READ MORE

ECU 000412.16 indicates that the exhaust gas recirculation (EGR) exhaust temperature is moderately above the specification. This could indicate more significant issues such as a malfunctioning EGR valve, a severely clogged EGR cooler, or operational inefficiencies.

READ MORE

Error code ECU 000412.15 is activated when the exhaust gas recirculation (EGR) exhaust temperature is detected slightly above the normal specifications. This minor deviation might be caused by slight clogging in the EGR cooler or minor issues with the EGR valve not opening sufficiently.

READ MORE

ECU 000412.04 is set off when the exhaust gas recirculation (EGR) exhaust temperature sensor’s input voltage falls below the minimum required level, indicating a potential short to ground. This condition can lead to inaccurate or unreliable temperature readings.

READ MORE

This error code, ECU 000412.03, occurs when the input voltage at the EGR exhaust temperature sensor exceeds the maximum specified limit, likely due to a short to 12 volts. This fault can result in inaccurate temperature readings from the sensor.

READ MORE