Error code CSC 523949.05 is generated when the current in the circuit of the solenoid valve for raising the cab suspension is too low. This condition can be caused by an open circuit, which can prevent the solenoid valve from functioning properly.

READ MORE

The error code CSC 523949.03 is detected when the solenoid valve supply voltage for raising the cab suspension is too high, typically indicating a short to a 12-volt source. This condition can impair the functionality of the solenoid valve and the cab suspension system.

READ MORE

Error code CSC 523948.06 is triggered when the control software detects that the current in the circuit of the solenoid valve for lowering the cab suspension is too high. This typically indicates a short to ground, which can lead to improper operation or damage to the solenoid valve and associated systems.

READ MORE

Error code CSC 523948.05 is generated when the current in the circuit of the solenoid valve for lowering the cab suspension is too low. This condition can be caused by an open circuit or over-temperature, which can impede the solenoid valve’s ability to function properly.

READ MORE

The error code CSC 523948.03 is triggered when the solenoid valve supply voltage for lowering the cab suspension is too high, typically indicating a short to a 12-volt source. This condition can impair the functionality of the solenoid valve and the cab suspension system.

READ MORE

Error code CSC 523671.19 indicates that an incorrect signal has been received from the right hand reverser lever. This lever is essential for controlling the direction of the vehicle, and a faulty signal can impair operation. This code is informational, suggesting that other AIC (Armrest Interface Control) codes should be diagnosed first.

READ MORE

Error code CSC 523666.04 is generated when the supply voltage at the input of the rear chassis control unit falls below 9 V. Low voltage conditions can impair the operation of the control unit and associated systems, potentially leading to reduced performance or functionality.

READ MORE

This error code CSC 523666.03 is triggered when the control software detects that the supply voltage at the input of the rear chassis control unit exceeds 16 V. This condition typically indicates a short circuit within the wiring harness, which can lead to overvoltage conditions that might damage electronic components.

READ MORE

Error code CSC 522763.19 indicates a fault in the signal transmission from the left hand reverser lever. This lever is crucial for controlling the direction of the vehicle, and a faulty signal can impair the operation and safety of the machine.

READ MORE

Error code CSC 522457.19 is generated when the control software detects that the transmission output speed cannot be determined or provided on the CAN bus by the PTA control software and the PLC control software. This condition results in the transmission of a replacement value, leading to this diagnostic trouble code. The error indicates that…

READ MORE

The error code CSC 522288.06 indicates that the control software has detected an excessively high current in the proportional solenoid valve responsible for damping the cab suspension. This issue may be caused by a short circuit (potentially a short to ground), mechanical defects in the valve, or electrical overloading, which can impede the proper function…

READ MORE