This error code, XSC 522390.12, is generated when no valid information from the implement is received via the implement CAN Bus. This indicates a potential problem in the CAN Bus network or the implement control software, affecting the data communication necessary for Tractor-Implement Automation™.

READ MORE

This error code, XSC 522390.11, is generated when the come-home mode is activated on tractors with AutoPowr™/IVT™ transmission, leading to the deactivation of all functions of the Tractor Implement Automation™.

READ MORE

This error code, XSC 522390.09, is generated when no valid information from the implement is received via the implement CAN Bus. This issue can be caused by problems in the CAN Bus network or issues with the implement control software.

READ MORE

This error code, XSC 522387.07, is generated when the XSC control software commands a steering movement but fails to detect a corresponding signal from the wheel angle sensor (WAS), or if the received signal is too low. This can indicate an issue with the sensor, wiring, or the control software itself.

READ MORE

This error code, XSC 003842.01, indicates that the voltage at channel 2 of the wheel angle sensor is below 0.25 volts. Despite this low voltage, the value measured by the XMC control software is within the acceptable range, suggesting a potential issue with the sensor or signal processing.

READ MORE

This error code, XSC 003842.00, indicates that the voltage at channel 2 of the wheel angle sensor exceeds 2.25 volts. Despite this high voltage, the value measured by the XMC control software is within the acceptable range, suggesting a potential issue with the sensor or signal processing.

READ MORE

This error code, XSC 003841.01, indicates that a voltage below 0.5 volts is registered at channel 1 of the wheel angle sensor. Despite this low voltage, the value measured by the XMC control software is within the acceptable range, suggesting a potential issue with the sensor or signal processing.

READ MORE

This error code, XSC 003841.00, indicates that a voltage over 4.5 volts is registered at channel 1 of the wheel angle sensor. Despite this high voltage, the value measured by the XMC control software is within the acceptable range, suggesting a potential issue with the sensor or signal processing.

READ MORE

This error code, XSC 003512.04, indicates that the voltage supply to the 5-volt components has dropped below 4.75 volts. This condition suggests a short to ground or an internal fault within the control unit, which can disrupt normal operation and damage the components.

READ MORE

This error code, XSC 003512.03, indicates that the voltage supply to the 5-volt components has exceeded 5.25 volts. This condition typically suggests a short to 12 volts, which can damage the 5-volt components and disrupt normal operation.

READ MORE