This error code, SCO 000926.03, indicates that the supply voltage (BAT) for the stepper motor of E-SCV XIII has risen above 16 volts. Excessive voltage can damage the stepper motor and prevent it from functioning correctly.

READ MORE

This error code, SCO 000925.04, indicates that the voltage at the stepper motor input for E-SCV XII has fallen below 9 volts. This condition suggests a potential short to ground, which can prevent the stepper motor from operating correctly.

READ MORE

This error code, SCO 000925.03, indicates that the supply voltage (BAT) for the stepper motor of E-SCV XII has risen above 16 volts. Excessive voltage can damage the stepper motor and prevent it from functioning correctly.

READ MORE

This error code, SCO 000924.04, indicates that the voltage at the stepper motor input for E-SCV X and E-SCV XI has fallen below 9 volts. This condition suggests a potential short to ground, which can prevent the stepper motors from operating correctly.

READ MORE

This error code, SCO 000924.03, indicates that the supply voltage (BAT) for the stepper motors of E-SCV X and E-SCV XI has risen above 16 volts. Excessive voltage can damage electronic components and disrupt the operation of the stepper motors.

READ MORE

This error code, SCO 000630.13, indicates that one or more functions in the control software are active but have not yet been calibrated. Proper calibration is necessary for accurate operation.

READ MORE

This error code, SCO 000629.12, indicates that a fault occurred during the launch of the software, specifically related to the watchdog timer. This fault can prevent the control software from operating correctly.

READ MORE

This error code, SCO 000628.02, indicates an error when reading the internal module (EEPROM) of the control software. This internal fault can affect the normal operation of the control software.

READ MORE

This error code, SCO 000190.19, indicates that the engine speed cannot be determined and provided on the CAN Bus by the ECU control software. A replacement value is transmitted, generating this diagnostic trouble code. In its active state, this fault can also trigger a higher-priority diagnostic trouble code in the ECU control software.

READ MORE

This error code, SCO 000190.09, is generated when a data transfer problem occurs between the ECU control unit and the SCO control software. The reception of one, several, or all of the CAN messages transmitted by the ECU control unit is intermittent or non-existent. This indicates a problem in the CAN BUS or in the…

READ MORE

This error code, SCO 000190.02, indicates that the engine speed is too low during the front hitch calibration process. Adequate engine speed is required to perform accurate calibration.

READ MORE