Error code BIF 522426.19 is reported when the output that controls the rear window wiper relay on Power Module (HF) PC6 is erroneously energized by more than one control unit. This diagnostic trouble code indicates a communication error in the CAN BUS system where multiple units are sending conflicting signals to activate the rear window…

READ MORE

Error code BIF 522426.12 is triggered when the Power Module (HF) PC6 detects a current in excess of 1 amp at the output for the rear window wiper relay (lead 2026), even though the rear window wiper is switched off. This condition typically indicates a shorted circuit or an internal fault within the power module…

READ MORE

Error code BIF 522426.09 is reported when there is a disruption in the data communication between the Power Module (HF) PC6 and the BIF control unit, specifically affecting the K06/05 or K02/05 relay for the rear window wiper. This fault occurs due to intermittent or nonexistent reception of CAN messages from the BIF to the…

READ MORE

Error code BIF 522426.04 is triggered when the High Frequency (HF) Power Module PC6 detects an abnormally high current of more than 1 amp at the rear window wiper relay output (lead 2026) while the relay is activated. This high current typically indicates a short to ground within the circuit, which can lead to potential…

READ MORE

Error code BIF 522426.01 is generated when the High Frequency (HF) Power Module PC6 detects a voltage of less than 3 volts at the relay supplying power to the rear window wiper (lead 2026), specifically when the wiper is activated. This low voltage condition indicates a possible fault in the power supply to the relay,…

READ MORE

Error code BIF 522426.00 is triggered when the High Frequency (HF) Power Module PC6 detects a current exceeding 40 amps at outputs A3 and D3. This diagnostic trouble code specifically relates to the K06/05 or K02/05 relay for the rear window wiper. The excessive current typically indicates a short to ground or a defective component…

READ MORE

Error code BIF 002876.02 is activated when the control unit receives input signals for both the left and right turn signals simultaneously from the turn signal switch (S127). This condition typically indicates a malfunction of the turn signal lever or a fault within the electrical circuit that manages the turn signals. Receiving conflicting signals like…

READ MORE

Error code BIF 002873.31 is an informational message for the operator, triggered when the tractor’s worklights remain activated while the vehicle is traveling at speeds exceeding 23 km/h (14.3 mph). This alert is designed to inform the operator that using worklights at higher road speeds may not comply with road safety regulations or could potentially…

READ MORE

Error code BIF 002865.02 is triggered when the control unit detects several implausible input signals from the wiper switch (S128), which controls both the windshield and rear window wipers. This fault typically indicates either a malfunction in the wiper switch itself or an issue within the wiring circuit, specifically affecting the rear window wiper operations.

READ MORE

Error code BIF 002863.02 is reported when the control unit receives several implausible input signals simultaneously from the wiper switch (S128) designated for windshield and rear window wipers. This condition typically suggests a malfunction in the wiper switch itself or a fault within the associated circuit, affecting the proper operation of the windshield wipers.

READ MORE

Error code BIF 002348.19 is set off when multiple control units erroneously energize the output for switching the full beam headlights on the cab frame (E07/E08). This indicates a conflict in the CAN BUS messages where more than one unit is attempting to control the same function, potentially leading to erratic operation or conflicts within…

READ MORE