This error code, SCO 000177.02, indicates that the hydraulic oil temperature is too low during front hitch calibration. The hydraulic oil must be heated above 40°C (104°F) for proper calibration.

READ MORE

This error code, SCO 000177.01, indicates that the hydraulic oil temperature has fallen below -25°C (-13°F). The function of the E-SCVs (electronic selective control valves) is highly dependent on the hydraulic oil temperature: Hydraulic oil temperature below -25°C (-13°F): No function of E-SCVs. Hydraulic oil temperature between -15°C and -25°C (5°F and -13°F): No function…

READ MORE

This error code, SCO 000168.04, indicates that the supply voltage (BAT) for the control software has dropped below 9 volts. Insufficient voltage can prevent the control software from operating properly.

READ MORE

This error code, SCO 000168.03, indicates that the supply voltage (BAT) for the control software has risen above 16 volts. Excessive voltage can damage electronic components and disrupt the operation of the control software.

READ MORE

This error code, SCO 000158.04, indicates that the supply voltage (ELX) for the control software has dropped below 9 volts. This insufficient voltage can hinder the proper functioning of the control software.

READ MORE

This error code, SCO 000084.19, is generated when the transmission output speed signal cannot be determined and provided on the CAN Bus by the PTA control software (AutoPowr™/IVT™ transmission), PTQ control software (PowrQuad™ transmission), or PTD control software (DirectDrive transmission). When this occurs, a replacement value is transmitted, generating this diagnostic trouble code. In its…

READ MORE

This error code, SCO 000084.14, is generated when the travel speed of the equipment exceeds the acceptable limit while the return-to-position function is activated. This serves as a warning to the operator that the current speed is too high for safe operation of the return-to-position function.

READ MORE