This diagnostic trouble code (DTC) UIC 524254.31 is generated if the UIC control unit detects a problem with the circuit of the transmission enable relay (K06/03 or K02/03). This indicates a defective relay, or a problem with the ground circuit (lead 6003), or with the circuit of the control lead (6064). Relay K06/03: Tractors up…

READ MORE

This diagnostic trouble code (DTC) UIC 524188.01 is generated when the control unit internally detects that too much time has elapsed.

READ MORE

This operator information (DTC) UIC 524180.31 is generated when the comehome mode is activated (K07/04 or K03/04 connector for comehome feature in COME HOME position). The operator is informed that they should release the clutch pedal to gain access to the next stage of the comehome function. This code is informational and not stored.

READ MORE

This operator information (DTC) UIC 524180.14 is generated when the comehome mode is activated (K07/04 or K03/04 connector for comehome feature in COME HOME position). The operator is informed that they should depress the clutch pedal fully to gain access to the next stage of the comehome function. This code is informational and not stored.

READ MORE

This operator information (DTC) UIC 524180.07 is generated when the comehome mode is activated (K07/04 or K03/04 connector for comehome feature in COME HOME position). The operator is informed that they should depress the clutch pedal if they want to stop the tractor. This code is informational and not stored.

READ MORE

This diagnostic trouble code (DTC) UIC 524173.07 is generated if the control unit detects a constant voltage signal (+0.2 volts) from a lightly applied clutch pedal over a period of at least 10 minutes. This indicates an adjustment error in the clutch pedal.

READ MORE

This diagnostic trouble code (DTC) UIC 524173.04 is generated when the control unit measures a voltage of less than 0.5 volts at the signal input from channel 1 of the potentiometer (B65, lead 6114). This indicates a problem at the signal lead or a problem with the potentiometer supply voltage.

READ MORE

This diagnostic trouble code (DTC) UIC 524173.03 is generated when the control unit measures a voltage of more than 4.5 volts at the signal input from channel 1 of the potentiometer (B65, lead 6114). This indicates a problem at the signal lead or at the potentiometer ground connection.

READ MORE

This diagnostic trouble code (DTC) UIC 524173.02 is generated when the control unit detects a mismatch between the output signals of the clutch pedal potentiometer (B65). The voltage at channel 1 (lead 6114) must be double the voltage of channel 2 (lead 6007).

READ MORE

This diagnostic trouble code (DTC) UIC 524169.30 is generated when the following conditions are present for more than 10 minutes: Voltage on the left potentiometer below 0.6 volts while the voltage on the right potentiometer is below 1.4 volts. Voltage on the left potentiometer above 1.4 volts while the voltage on the right potentiometer is…

READ MORE

This diagnostic trouble code (DTC) UIC 524169.04 is generated when the control unit measures a voltage below 0.5 volts at the signal input of the left brake pedal potentiometer. This indicates a problem at the signal lead or a problem with the potentiometer supply voltage.

READ MORE